Purifying DNA from an Agarose Gel

Gel purification allows you to isolate and purify DNA fragments based on size. The procedure starts with standard agarose gel electrophoresis, which separates DNA by their length in base pairs. Following electrophoresis, you can cut DNA bands out of the agarose gel and purify the DNA samples. This is a commonly used technique for molecular cloning, such as PCR- or restriction enzyme-based cloning.

Protocol: Gel Purification

1. Follow the Agarose Gel Electrophoresis Protocol with the following amendments:

• Gel purification is most efficient with lower % agarose gels, so you will want to stay in the 0.7-0.8% range if possible.
• You will want nice crisp bands. This can be achieved by using a wider gel comb and running the gel at a lower voltage.
• You will want to have enough space around each band to cut without having DNA in other lanes contaminating your sample. To accomplish this, it is best to skip lanes between samples and between the ladder and nearest sample.
• To minimize the risk of DNA damage, it is best to limit the UV exposure of the DNA. Therefore, it is a bad idea to use a gel imager to take a picture of the gel before cutting out the bands and you will want to use long-wavelength UV for as short a time as possible to get the bands cut out.

• To protect the UV box, it is a good idea to place the gel on a glass plate if available. Unlike the plastic tray, this will not significantly reduce the UV, but will protect the UV box from being cut by the razor blade.
• Try to get as little excess gel around the band as possible. To do so, it is often important to take the excised band, lay it down on the UV box and trim the top, bottom and sides with the razor blade. This is especially important during the DNA purification step, as many kits cannot handle more than a certain total volume of gel per reaction.

Note: It is usually important to determine the concentration of the DNA that you isolated before proceeding to your next intended step with the now gel purified DNA. Find more information about DNA quantification here.

Tips and FAQ

How do you get better resolution of bands?

A couple simple ways to increase the resolution (crispness) of your DNA bands include: a) running the gel at a lower voltage for a longer period of time; b) using a wider gel comb; or c) loading less DNA in the well.

How do you get better separation of bands?

If you have similarly sized bands that are running too close together you can adjust the gel percentage to get better separation. A higher percentage agarose gel will help resolve smaller bands from each other, and a lower percentage gel will help separate larger bands.

10% Rule

For each sample you want to load on a gel, make 10% more volume than needed because several microliters can be lost in pipetting. For example, if you want to load 1.0 μg in 10μL, make 1.1μg in 11μL.